Slim & fitted.

All our shirts come as a slim fit with a clean and dart-less back for a more flattering look. Our unique Brazilian tailored cut introduces the engineering of a lightly curved shoulder yoke to more accurately trace the natural curve of the shoulders and upper back.  It tapers in around the waist and has a longer tail to improve fit without the nuisance of billowing. Oh, and we've improved the position of the armholes to allow for greater range of motion

BrancaShirt

If you normally wear regular fit shirts, we hope you can bear with us a little longer - please drop us an email and we will make sure you are the first to know when we roll out our regular shirt fits. 

Reunidas

Measuring guide.

Use these helpful tips to find your perfect fit. This guide requires using garments that fit you well as a point of reference. Then check with the table with our shirt measurements below. 

Reunidas Measurement Guide

1. Neck

Measure the circumference of your neck with at least one or two fingers of leeway, depending on preference. Round to the nearest half-inch.

2. Sleeve Length

Measure from the base of the neck at the centre point, where your shirt collar meets the yoke, over the shoulder and straight out to your wrist.

When using a shirt that fits well for reference: Begin at the centre of the back of the shirt, where the collar meets the yoke, then run the measuring tape to the top armhole seam and straight down to the edge of the cuff.

3. Chest

The chest measurement is taken 1-inch below the armhole, not pit-to-pit. Measure around the body, under the arm at the broadest part of the chest for a full chest measurement.

4. Waist

Your natural waist is the narrowest part of your torso. Measure the circumference of your torso at your natural waistline.


TABLE OF REUNIDAS SHIRT MEASUREMENTS BY COLLAR SIZE *1/2 measurements are just industry standards - double it to get your full circumference

TABLE OF REUNIDAS SHIRT MEASUREMENTS BY COLLAR SIZE

*1/2 measurements are just industry standards - double it to get your full circumference